Hair Cutting
Hair cutting requires special tools to be done in the best form. The most important of these tools are 6 cm wide scissors, 8 cm high blade cutters, a thick toothbrush, a fine, close-fitting toothbrush, and a long, wide-brimmed tooth that is tapered from the other end It can also be used to separate the hair from each other, as well as hair lifting tweezers, and water sprays to moisten the hair shaft before cutting. The neck cover can also be used to prevent the adhesion of hair cut to the body and clothing.
Hair cutting methods
- Before you start cutting hair must moisturize all the hair shaft by water sprayer so easy to comb, preferably comb hair with a thick brush and brush teeth in order to make the descent of the hair shaft all in the same direction.
- Cut the back of the hair (behind the back): The hair is combed horizontally from the top of the scalp to the end of the hair shaft, so that we get hair that is down and separated in parallel, and then we determine the level of length we want for the back hair, Wide and long hair loss as specified in a straight horizontal line free from aliasing. In case of aliasing, it can be repaired using a high-cut blade.
- After the combing of the hair shaft as explained in the previous step, the hair is cut using the high end of the comb so that it starts from the tip of the ear and crosses in a straight line through the hair shaft until the tip of the other ear, and comb the hair qualities that were separated by the thick thin comb The teeth are pulled to the front of the head, grouped together so that they are confined between the middle and index finger vertically, and determine the new length of the offspring by making the desired length a story of the cone outside, and by the high-cut scissors are cut in line parallel to the line of fingers.
- Background gradients: Background gradients can be obtained by following the same method as before, but with a simple difference: pulling the hair behind the ears to the back of the head so that it is raised to the top of the head at an everted angle and then gather the hair shaft between the fingers and cut it as shown in step Previous.
- Cut the caudal: The cuttings located at the top of the head are collected at the top of the forehead by the high side of the comb and pull the hair shaft obliquely to one side and start cutting it from the far side with a short length, taking into account the length of the chalk as we approach the selected side.